Technologies Network Router User Manual

SECTION 4 " Configuration
6710 Access Point User’s Guide 4-35
8. Does the radio network contain a secondary Ethernet
LAN(s) with connected nodes that do not periodically
generate traffic?
Answer Setting
Yes Outbound to Secondaries/Unicast/Enabled
Alternatively, you can configure permanent
addresses in the Static Address Table (page 4-42).
9. Does the radio network contain a secondary Ethernet
LAN(s) with connected nodes that must receive
multicast or broadcast frames?
Answer Setting
Yes Inbound/Multicast/Primary
Outbound to Secondaries/Multicast/Registered
or
Inbound/Multicast/Enabled
Outbound to Secondaries/Multicast/Registered
Comments:
" You can use the settings listed in the above chart
in combination with a Flood Register setting of
Multicast for selected secondary Ethernet LANs,
if nodes in the radio network that must receive
broadcast or multicast frames are restricted to
those LANs.
" You should use the Outbound to
Stations/Enabled setting if wireless stations
must receive multicast frames. For example,
TCP/IP wireless stations may need to receive
broadcast ARP requests.
" You can use Ethernet filters to reduce multicast
flooding for any Inbound or Outbound to
Secondaries setting other than Disabled.