Datasheet

Trakker Antares 241X Hand-Held Terminal Service Manual nugget
2-22
10. (2415 only) Install the radio card.
a. Compare the connector tabs on the radio card to the connector on the main PCB
to determine which way to insert the card.
b. Slide the radio card into the connector. Firmly press the card into the connector
until it stops.
c. Install the retaining block on the main PCB and tighten the screw to 0.226 Nm
(2 in-lb).
11. Close the terminal. For help, see “Closing the Terminal” on page 2-36.
Replacing the PDF 417 Scan Engine
Because finger oils can dissolve the reflective coating of the plastic mirrors, always
wear finger cots or non-powdered latex gloves when handling optical parts.
To replace the PDF 417 scan engine, you need the following tools:
• #0 Phillips screwdriver or T5 Torx screwdriver
• #1 Phillips screwdriver
• Torque screwdriver
Youalsoneedthefollowingscanengine:
• PDF 417 (P/N 591081S-001)
To replace the PDF 417 scan engine
1. Open the terminal. For help, see “Opening the Terminal” on page 2-4.
2. (2415 only) Remove the radio
card from the main PCB.
a. Remove the screw holding the
retaining block in place, and
remove the retaining block.
b. Slide the radio card out of the
connector on the main PCB.
Note: The antenna cables are not
shown for clarity.
241XM016.eps
Radio
card
Retaining
block
Screw