Datasheet

nugget Replacing Parts

2-21

3. Remove the two screws holding the scan engine assembly in place.

Scan engine

assembly

Antenna

Screw

(2 places)

241XM038.eps

4. Remove the scan engine assembly.

5. (2415 only) Turn the assembly over and remove the antenna.

6. Remove the three screws that hold the scan engine in place and remove the scan

engine.

7. Install the new scan engine in the scan engine bracket and secure it with the three

screws tightened to 0.226 Nm (2 in-lb).

8. (2415 only) Install the antenna. For help, see Step 6 for “Replacing the Antenna” on

page 2-18.

9. Install the scan engine assembly.

a. Place the assembly in the bottom

cover. Make sure the assembly is

firmly seated in the cover.

b. Slide the assembly toward the top

of the cover so that the front of the

assembly slides under the retainers.

c. Install the two screws that hold the

scan engine assembly in place and

tighten them to 0.565 Nm (5 in-lb).

Retainers

241XM025.eps