Datasheet

nugget Replacing Parts
2-19
2
• If you are installing a European
OpenAir antenna, orient the antenna
so that the antenna cable and the foam
padding faces opposite of the bracket
on the scan engine or linear imager
assembly. Make sure that the antenna
cable is positioned toward the top of the
bracket.
Antenna
Antenna cable
Foam
padding
Scan engine/
linear imager
assembly
241XM024.eps
7. If you removed a standard scan engine or PDF 417 scan engine in Step 3, install the
scan engine assembly.
a. Place the assembly in the bottom
cover. Make sure the assembly is
firmly seated in the cover.
b. Slide the assembly toward the top
of the cover so that the front of
the assembly slides under the
retainers.
c. Install the two screws that hold
the scan engine assembly in place
and tighten them to 0.565 Nm
(5 in-lb).
Retainers
241XM025.eps
8. If you removed an E1022 linear imager in Step 3, place the E1022 linear imager
assembly in the bottom cover and install the four screws that hold the assembly in
place. Tighten the screws to 0.565 Nm (5 in-lb).
9. Install the radio card.
a. Compare the connector tabs on the radio card to the connector on the main PCB
to determine which way to insert the card.
b. Slide the radio card into the connector. Firmly press the card into the connector
until it stops.
c. Install the retaining block on the main PCB and tighten the screw to 0.226 Nm
(2 in-lb).
10. Close the terminal. For help, see “Closing the Terminal” on page 2-36.