Datasheet

nugget Replacing Parts

2-17

4. Make sure the display lens is free from fingerprints and scratches. Remove the

adhesive backing from the display lens and carefully apply it to the new keypad

assembly. Firmly press the adhesive area of the new display lens onto the keypad

assembly.

5. Use an ionized air gun to blow any dust out of the interior of the terminal.

6. Install the LCD in the new keypad assembly. Follow Steps 7 through 12 for

“ReplacingtheLCD”onpage2-14.

7. Close the terminal. For help, see “Closing the Terminal” on page 2-36.

8. If necessary, attach the Clear Orbit label or the Oracle Ready label to the display

lens.

Replacing the Antenna (2415 Only)

To replace the antenna, you need the following tool:

• #1 Phillips screwdriver

• Torque screwdriver

You also need one of the following parts:

• Dual micropatch (802.11b) antenna (P/N 590993-001)

• Single micropatch (OpenAir) antenna (P/N 590995-001)

• Dipole (European OpenAir) antenna (P/N 069769-001)

To replace the antenna

1. Open the terminal. For help, see “Opening the Terminal” on page 2-4.

2. Remove the radio card from the

main PCB.

a. Remove the screw holding the

retaining block in place, and

remove the retaining block.

b. Slide the radio card out of the

connector on the main PCB.

Note: The antenna cables are not

shown for clarity.

241XM016.eps

Radio

card

Retaining

block

Screw