Datasheet

nugget Replacing Parts

2-15

Replacing the Display Lens

To replace the display lens, you need the following tools:

• #1 Phillips screwdriver

• Torque screwdriver

You also need the following parts:

• One of these display lenses

• 2410 (P/N 069423-003)

• 2415 (P/N 069427-003)

• Clear Orbit Label (if necessary) (P/N 071228-001)

• Oracle Ready Label (if necessary) (P/N 072558-001)

To replace the display lens

1. Open the terminal. For help, see “Opening the Terminal” on page 2-4.

2. Remove the LCD. Follow Steps 2 through 6 for “Replacing the LCD” on page

2-13.

3. From the inside of the terminal, push the display lens out of the display window

area of the top cover. You may need to clean the top cover to remove any adhesive

residue left by the display lens.

4. Make sure the new display lens is free from fingerprints and scratches. Remove the

adhesive backing from the new display lens and carefully apply it to the top cover.

Firmly press the adhesive area of the new display lens onto the top cover.

Use an ionized air gun to blow any dust out of the interior of the terminal.

5. Install the LCD. Follow Steps 7 through 11 for “Replacing the LCD” on page 2-14.

6. Close the terminal. For help, see “Closing the Terminal” on page 2-36.

7. If necessary, attach the Clear Orbit or Oracle Ready label to the display lens.

Replacing the Keypad Assembly (Top Cover)

To replace the keypad assembly, you need the following tool:

• #1 Phillips screwdriver

• Torque screwdriver