Datasheet

Trakker Antares 241X Hand-Held Terminal Service Manual nugget
2-14
4. Gently lift the main PCB out of the top cover. Be careful not to rip the connection
between the main PCB and the display/beeper flex cable.
5. Remove the display/beeper flex cable from the LCD.
Display/beeper
flex cable
LCD
Screw
(four places)
Beeper
Top cover
241XM022.eps
6. Remove the four screws holding the LCD in place and remove the LCD.
7. Install the new LCD and tighten the screws to 0.226 Nm (2 in-lb).
8. Connect the display/beeper flex cable to the new LCD.
9. Install the main PCB.
10. Connect the keypad flex cable to the main PCB.
11. Install the radio or memory card.
a. Compare the connector tabs on the radio or memory card to the connector on
the main PCB to determine which way to insert the card.
b. Slide the radio or memory card into the connector. Firmly press the card into
the connector until it stops.
12. Install the retaining block on the main PCB and tighten the screw to 0.226 Nm
(2 in-lb).
13. Close the terminal. For help, see “Closing the Terminal” on page 2-36.