Datasheet

nugget Replacing Parts

2-13

Replacing the LCD

To replace the LCD, you need the following tools:

• #0 Phillips screwdriver or T5 Torx screwdriver

• #1 Phillips screwdriver

• Torque screwdriver

You also need the following part:

• LCD (P/N 071363S-001)

To replace the LCD

1. Open the terminal. For help, see “Opening the Terminal” on page 2-4.

2. Remove the radio or memory card

from the main PCB.

a. Remove the screw holding the

retaining block in place, and

remove the retaining block.

b. Slide the radio or memory

card out of the connector on

the main PCB.

Note: The antenna cables (2415

only) are not shown for clarity.

241XM036.eps

Radio or

memory card

Retaining

block

Screw

3. Remove the keypad flex cable from the main PCB.

Keypad

flex cable

Main PCB

241XM013.eps