Datasheet

Trakker Antares 241X Hand-Held Terminal Service Manual nugget
2-12
5. Remove the adhesive backing from the new beeper, and attach it to the top cover.
Make sure that the beeper is aligned with the alignment edge on the top cover.
Display/beeper
flex cable
LCD
Screw
(four places)
Alignment
edge
Beeper
Top cover
241XM020.eps
6. Connect the display/beeper flex cable to the LCD.
7. Connect the display/beeper flex cable to the main PCB.
8. Install the main PCB.
9. Connect the keypad flex cable to the main PCB.
10. Install the radio or memory card.
a. Compare the connector tabs on the radio or memory card to the connector on
the main PCB to determine which way to insert the card.
b. Slide the radio or memory card into the connector. Firmly press the card into
the connector until it stops.
11. Install the retaining block on the main PCB and tighten the screw to 0.226 Nm
(2 in-lb).
12. Close the terminal. For help, see “Closing the Terminal” on page 2-36.