Datasheet

Trakker Antares 241X Hand-Held Terminal Service Manual nugget
2-10
5. Turn the main PCB over and remove the display/beeper flex cable from the main
PCB.
Main P
CB
To
p
c
ov
er
Displa
y
/beepe
r
fl
e
x
cab
l
e
241XM035.e
ps
6. Connect the display/beeper flex cable to the new main PCB.
7. Install the new main PCB.
8. Connect the keypad flex cable to the main PCB.
9. Install the radio or memory card.
a. Compare the connector tabs on the radio or memory card to the connector on
the main PCB to determine which way to insert the card.
b. Slide the radio or memory card into the connector. Firmly press the card into
the connector until it stops.
10. Install the retaining block on the main PCB and tighten the screw to 0.226 Nm
(2 in-lb).
11. Close the terminal. For help, see “Closing the Terminal” on page 2-36.
12. Use the configuration you noted in Step 1 and standard practices for the Trakker
Antares Download and Configuration Tool to load the correct configuration,
firmware, and application software.