Datasheet

nugget Replacing Parts

2-9

You also need one of the following parts:

• 2MB main PCB (P/N 071589S-002)

• 4MB main PCB (P/N 071588S-002)

To replace the main PCB

1. Open the terminal. For help, see “Opening the Terminal” on page 2-4.

Make sure you note the configuration on the serial number label on the bottom

cover.

2. Remove the radio or memory card

from the main PCB.

a. Remove the screw holding the

retaining block in place, and

remove the retaining block.

b. Slide the radio or memory

card out of the connector on

the main PCB.

Note: The antenna cables (2415

only) are not shown for clarity.

241XM036.eps

Radio or

memory card

Retaining

block

Screw

3. Remove the keypad flex cable from the main PCB.

Keypad

flex cable

Main PCB

241XM013.eps

4. Gently lift the main PCB out of the top cover. Be careful not to rip the connection

between the main PCB and the display/beeper flex cable.