Datasheet

Trakker Antares 241X Hand-Held Terminal Service Manual nugget
2-6
3. Remove the antenna cable or
cables from the radio card.
a. If necessary, carefully cut the
mount strap in half.
b. Disconnect the antenna cable
or cables from the radio card.
4. Install the new radio card.
a. Compare the connector tabs
on the new radio card to the
connector on the main PCB to
determine which side of the
new radio card is the back
(faces the main PCB).
241XM014.eps
Mount
strap
Main
PCB
Cut
here
b. Attach the mount strap to the back of the radio card by removing the backing
from the adhesive area shown and applying the mount strap to the radio card.
Mount
strap
Remove
backing
Radio
card
Mount
strap
241XM017.eps
c. Turn the radio card over and slide it into the connector. Firmly press the radio
card into the connector until it stops.
5. Install the retaining block on the main PCB and tighten the screw to 0.226 Nm
(2 in-lb).