User Manual

Chapter 2 — Configuring the PB50
PB50 Portable Label Printer User’s Guide 33
Where c:/test.pfx is the location and name of the certificate
and export is the passphrase.
• Send the following commands to set a common name for
server 1 and server 2:
setup “8021x”,”.SERVER_CN1”,xxxxxxxxxx <ETX>
setup “8021x”,”.SERVER_CN2,xxxxxxxxxx <ETX>
Where xxxxxxxxxx can be a value from 0 to 64 characters.
• Send the following command to make sure your values
match those used by the access point:
setup write “8021x”,”uart1:”
• You may need to send the following command several
times for the wireless station to connect:
setup “wlan”,”ACTIVE”,”1”<ETX>
Setting Up Serial Communications
You can use a serial cable (P/N 075497-001) to connect the
PB50 to a PC or a mobile computer. For the mobile computer,
you may need to purchase a serial adapter. For more information,
contact your local Intermec sales representative.
Before you can establish a serial connection, you need to make
sure that the settings on the PC or mobile computer match those
of the PB50.
To connect the PB50 to a PC or mobile computer
1 Connect the 8-pin circular DIN connector to the serial port
on the PB50.
Serial Port Settings on the PB50
Parameter Default Setting
Baud rate 115200
Data bits 8
Parity None
Stop bits 1
Flow control XON_XOFF