User Manual

Chapter 2 — Configuring the PB50

PB50 Portable Label Printer User’s Guide 29

Configuring Wireless Printing Using IPL

Use the following procedures to configure your PB50 with IPL

for wireless printing.

To configure the printer to use WEP authentication

1 Send the following commands to login as an admin and set

the SSID:

<STX><ESC>.s,su -p pass admin<ETX>

<STX><SI>ws,SSID, xxxxx<ETX>

Where xxxxx can be from 0 to 32 alphanumeric characters.

2 Send the following commands to configure the WEP keys.

The following example sets WEP key 1 to 1234 and enables

WEP key 1.

3 Send the following command to activate the settings.

<STX><SI>ws,ACTIVE,1<ETX>

To configure the printer to use WPA-PSK or WPA2-PSK mode

1 Send the following commands to login as an admin and set

the SSID:

<STX><ESC>.s,su -p pass admin<ETX>

<STX><SI>ws,SSID, xxxxx<ETX>

Where xxxxx can be from 0 to 32 alphanumeric characters.

2 Send the following commands to set up WPA-PSK or WPA2-

PSK authentication:

<STX><SI>ws,WPA_PSK, xxxxxxxxxx<ETX>

Where xxxxxxxxxx is a value between 8 and 64 characters.

3 Send the following command to activate the settings:

<STX><SI>ws,ACTIVE,1<ETX>

To configure the PB50 to use WPA or WPA2 Enterprise mode

1 Send the following commands to login as an admin and set

the SSID:

<STX><ESC>.s,su -p pass admin<ETX>

<STX><SI>ws,SSID, xxxxx<ETX>