User's Manual

MobileLAN WA21 Radio Replacement Instructions 7
2100I.002
Antenna
cable
assembly
Lock
washer
Nut
PICTURE – UPDATE (Too much detail)
4 If necessary, repeat Steps 1 through 3 for the other antenna
cable assembly.
5 If you are installing an 802.11a full-range radio, two antennas
shipped in the upgrade kit. Install the antennas.
a Feed the antenna wire through the antenna cable assembly
b Screw the antenna onto the assembly.
c Verify that the antenna bends in the proper direction.
Once you have verified that the antenna is oriented in
the direction that will achieve the best coverage, do not
rotate the antenna as you will break the antenna cables.
6 Carefully press the antenna cable sockets onto the plugs on
the radio. Make sure that the antenna cables are not crossed.
If you are using only one antenna, use the rightmost plug on
the radio.
7 Screw on the antennas or antenna cables.
PICTURE – Antenna cable
installation.