User's Manual

6 MobileLAN WA21 Radio Replacement Instructions
WA21I003.eps
3 Push the radio down until it locks in the spring clips.
4 Orient the retaining clip so that the bevel faces the antenna
ports.
Retaining
Clip
Clip
bevel
Radio
WA21I005.eps
5 Install the retaining clip over the radio and push down until
both sides lock into place.
Installing the Antenna Cable Assembly
1 From the inside of the access point, insert an antenna cable
assembly through an antenna port. If you are using only one
antenna, make sure you use antenna port 2 or antenna port 4.
These are the primary ports.
2 From the outside of the access point, place the lockwasher on
the antenna cable assembly and then screw on the nut.
3 Tighten the nut.