User's Manual

MobileLAN WA21 Radio Replacement Instructions 11
certification label. Note the first eight characters of the
configuration matrix string—these are the first eight
characters in the new configuration matrix string.
2 Identify the radios in slots 1 and 2. The shipping label on the
radio upgrade kit box contains the 3-digit code or you can use
this table:
Radio 3-Digit Code
802.11b radio 704
802.11a full-range radio 904
802.11a mid-range radio 954
No radio 000
3 Write down the new 14-character configuration matrix string.
4 Connect the access point to a terminal or PC using an RS-
232 null modem cable.
5 Plug the power cable into a power source and then into the
access point. The access point boots.
6 When the message <Press any key within 5 seconds to enter
the UAP monitor> appears, press a key to enter the UAP
Monitor.
7 At the AP (ap>) prompt, type zmt and press Enter.
8 In the password field, type matrix and press Enter.
9 Type ma xxxxxxxx111222, where xxxxxxxx111222 is the new
configuration matrix string. Press Enter. When you enter a
valid configuration matrix string, the confirmation message
“passed” appears on the screen.
10 Type x and press Enter to exit the matrix menu.
11 At the AP prompt, type mr to verify the configuration matrix
string. The manufacturing record appears onscreen, including
the configuration matrix string.
12 Type b and press Enter to reboot the access point.