User Manual

Chapter 3 — Troubleshooting and Maintaining the PB22/PB32
5 Extract the .zip file to a folder on your computer.
You have options for upgrading the firmware based on whether your
PB22/PB32 has a Bluetooth radio or an 802.11 b/g radio. Use one of
the following procedures to upgrade your printer firmware. Your
printer should reboot after you finish upgrading the firmware. If it
does not reboot, you will need to cold boot the printer. For help, see
“Cold Booting the PB22/PB32” on page 48.
To upgrade your printer using PrintSet
1 Download the latest version of PrintSet from the Intermec web
site at www.intermec.com.
2 Select File > Add Printer to start the Add Printer Wizard which
guides you through the process of adding your printer.
3 Select your printer under My Printers and then go to Printer >
Firmware Wizard.
The Firmware Wizard guides you through the necessary steps to
update your firmware.
To upgrade your printer using a serial connection
1 Make sure you have established a serial communications between
your PC and the PB22/PB32. For help, see “Setting Up Serial
Communications” on page 36.
2 Use Fingerprint, IPL, or ESC/P commands to send the upgrade file
to the printer.
For help with Fingerprint, IPL, or ESC/P commands and information,
see either the Fingerprint Programmer’s Reference Manual
(P/N 937-005-xxx), the IPL Programmer’s Reference Manual
(P/N 937-007-xxx), or the ESC/P Programmer’s Reference Manual
(P/N 937-010-xxx). You can download these documents from the
Intermec web site at www.intermec.com.
PB22/PB32 Portable Label and Receipt Printer User’s Guid 49