User Manual

Chapter 3 — Troubleshooting and Maintaining the PB22/PB32
.
.
4 Press until you reach Data Dump and then press
5 Press
to select Yes and then press
6 Cold boot the printer to exit Dump mode. For help, see the next
procedure, “Cold Booting the PB22/PB32.”
Cold Booting the PB22/PB32
You rarely need to cold boot the PB22/PB32 printer, unless you are
upgrading the firmware. If your printer occasionally locks up, you will
want to cold boot it. A cold boot reinitializes the 802.11 radio and
clears the working memory.
Note: The Setup menu is not affected by a cold boot. Your printer
retains all of your configuration settings after the printer powers
back up.
To reset the PB22/PB32
1 Disconnect the PB22/PB32 from power if externally powered.
2 Remove the battery from the PB22/PB32 for at least one second.
3 Insert the battery back into the PB22/PB32.
4 Reconnect external power if your PB22/PB32 is externally
powered.
Upgrading the Firmware
The latest firmware and software is always available for download
from the Intermec web site at www.intermec.com.
To download firmware updates
1 Go to the Intermec web site at www.intermec.com.
2 Click Support > Downloads.
3 In the Select a Product field, choose PB22/PB32 mobile printer.
The latest available software displays on the page.
4 Download the latest firmware version to your computer. Make
sure you choose the correct firmware upgrade for your IPL,
Fingerprint, or ESC/P printer.
PB22/PB32 Portable Label and Receipt Printer User’s Guide 48