User's Manual Supplement

For Users in the United States and Canada

Place this supplement in your manual.

This device complies with Part 15 of the FCC rules and with RSS-210 of Industry Canada.

Operation is subject to the following two conditions: (1) This device may not cause harmful

interference, and (2) This device must accept any interference received, including interference that

can cause undesired operation.

Federal Communications Commission Compliance

FCC Digital Emissions Compliance: This equipment has been tested and found to comply with

the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are

designed to provide reasonable protection against harmful interference in a residential installation.

This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used

in accordance with the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation. If this

equipment does cause harmful interference to radio or television reception, which can be determined

by turning the equipment off and on, the user is encouraged to try to correct the interference by one

or more of the following measures:

• Reorient or relocate the radio or television receiving antenna.

• Increase the separation between the computer equipment and receiver.

• Connect the equipment to an outlet on a circuit different from that to which the radio or

television receiver is connected.

• Consult the dealer or an experienced radio television technician for help.

For body and head worn operation, this radio has been tested and meets the FCC

RF exposure guidelines when used with the Intermec accessories supplied or

designated for this product. Use of other accessories may not ensure compliance

with FCC RF exposure guidelines. Specific Absorption Rate, or SAR, is a

measurement of radio frequency energy. The FCC permits a maximum SAR value

of 1.6 W/kg. The highest SAR value for this product when worn on the body, as

described in this user guide, is 0.176 W/kg.

Changes or modifications not expressly approved by Intermec could void the user’s

authority to operate this equipment.

For Users Outside of the United States and Canada

Place this supplement in your manual.

The Intermec product you purchased transmits and receives data using a 2.4 GHz Frequency

Hopping Spread Spectrum system.

Programming and configuration information for the transceivers is also provided in the host device

documentation. Please check the Intermec web site for additional documentation at

www.intermec.com.

Hereby, Intermec Technologies Corporation declares that this Bluetooth module is in compliance

with the essential requirements and other relevant provisions of R&TTE Directive (1999/5/EC).

This product has been assessed to the following standards: