User's Manual

2
For Users in the United States and Canada
Place this supplement in your manual.
This device complies with Part 15 of the FCC Rules and with RSS-210 of Industry Canada.
Operation is subject to the following two conditions: (1) This device may not cause harmful
interference, and (2) This device must accept any interference received, including interference that
can cause undesired operation.
Federal Communications Commission Compliance
This equipment is intended for operation in a commercial environment, in compliance with the
requirements for a Class A digital device, pursuant to Part 15 of the FCC Rules, and it must not be
used in a residential environment; however, it has also been tested and found to comply with the
more stringent requirements for a Class B device, pursuant to Part 15 of the FCC Rules. It
generates, uses, and can radiate radio frequency energy. If not installed and used in accordance with
the instruction manual, it may cause interference to radio communications. If this equipment causes
interference, the user will be required to correct the interference at the user’s own expense.
Warning
Avertissemen
t
Operation Warning
The user shall stay at least 20 cm (8 in) away from the antenna of this device, when
the device is in use in access points and other hosts, where higher gain antennas may
be used.
Warning
Avertissemen
t
Installation Warning
To comply with the FCC’s RF exposure requirements and minimize health hazards:
Host devices with higher gain antennas such as access points must be installed in
such a way that the user will be at least 20 cm (8 in) away from the antenna, when
the device is in use.
The installers should not forget that the burden of maintaining this distance is on
the installer and not the user. the antennas should be installed in a manner that
will comply with this requirement.
Caution
Conseil
Changes or modifications not expressly approved by Intermec could void the user’s
authority to operate this equipment.
Note
To maintain compliance with FCC Rules, the input/output (I/O) cables that
interconnect between the device and any peripheral must be as specified by Intermec.
Industry Canada Compliance
This Class B digital apparatus meets all requirements of the Canadian Interference-Causing
Equipment Regulations.
This device requires a radio license, unless it is used totally inside a building. (The user must obtain
this license.)