User's Guide
Table Of Contents
- Document Change Record
- Customer Support
- Who Should Read This Manual
- Related Documents
- Use the IP30
- About the IP30
- Use the Battery
- Attach or Remove the IP30
- Attach or Remove the IP30 from the CN70 or CN70e Mobile Computers
- Attach the IP30 to the CK70 or CK71 Mobile Computers
- Attach the IP30 to the CN3B or CN3F Mobile Computers
- Attach the IP30 to the CN4 Series Mobile Computer
- Attach the IP30 to the CK3 Series Mobile Computer
- Attach the IP30 to the CK61 Series Mobile Computer
- About Pairing the IP30 with the Mobile Computer
- Create and Use RFID Applications
- Upgrade and Troubleshoot the IP30
- Specifications
Chapter 1 — Use the IP30
IP30 Handheld RFID Reader User Guide 5
About the Ready-to-Work Indicator
The blue Ready-to-Work
TM
indicator shows when a connection is
established between your mobile computer and IP30. The next table
explains the different states of the Ready-to-Work indicator.
If there is no host activity after 5 minutes, the IP30 enters low power
mode. The IP30 remains Ready-to-Work as long as the mobile
computer maintains a communications link. To determine if the IP30
is ready to work, pull the trigger.
About the Ports
The USB version of the IP30 for the CK61 has two ports located on
the IP30 adapter. To access these ports, you must remove the port
cover.
On the bottom of the IP30 adapter, pull the port cover away from the
right side of the IP30.
Ready-To-Work Indicator Descriptions
LED Description
Off The IP30 is not yet ready for operation, or is in low power
mode.
Blinking The IP30 is not associated with or connected to the mobile
computer.
Steady A connection has been established between the IP30 and the
mobile computer.
COM 1
Power
port