User's Manual Part 2

Intermec EasyCoder F4 – Installation & Operation Ed. 272
Chapter 9 Options
The EasyCoder F4 comes with either a short side door, that only
covers the print unit, or with a long side door, that encloses the entire
paper compartment. The long side door has a slot for external paper
supply. The long side door is generally illustrated throughout this
manual, but pictures of the short side door can be found at the start of
this chapter and in chapter 5 “Paper Load/Quick-Load”.
The rewind unit is an optional device for peel-off operation, i.e. the
labels are separated from a backing paper (liner) after printing and
the backing paper is wound up on an internal spool. The rewind kit
also includes a guide shaft.
Peel-off cannot be combined with quick-load guides, see below.
The rotating paper supply spool is designed to fi t paper roll cores with
an internal diameter of 38 – 40 mm (1.5"). The spool can be fi tted in
the same positions as the paper hanger (see chapter 3 “Installation”).
Being factory installed, the position of the paper supply spool is not
intended to be changed by the operator.
the combination of high print speed and the momentum of large
and heavy paper roll (may cause slacks and jerks in the paper web
that may impair the printout quality, especially when printing
ladder style bar codes (i.e. with bars running across the web).
Thus, in case of print speed exceeding 150 mm/sec. (6"/sec,) in
combination with a full width paper roll and a paper roll diameter
of 200 mm (8") or more, we do not recommend the use of a rotating
paper supply spool.
The 3 inch/76 mm adapter is used in connection with a rotating
paper supply spool and makes it possible to use paper rolls with 3
inch/76 mm inner diameter paper cores. The 3" adapter cannot be
used in connection with a paper hanger.
The adapter is pressed onto the paper supply spool and held in
place by a screw
Side Doors
Rewind Unit
3" Adapter
Paper Supply
Spool