User's Manual Part 2

Intermec EasyCoder F4 – Installation & Operation Ed. 2 59
Chapter 7 Setup Mode
Setup Mode Overview, Part 5
(Intermec Fingerprint 7.31)
• Press Setup key to exit the Setup Mode.
SETUP:
NET-COM, NET1
SETUP:
PRINT DEFS
SETUP:
MEDIA
SETUP:
FEEDADJ
SETUP:
SER-COM, UART1
Standard Setup Mode
See Overview Part 1
Standard Setup Mode
See Overview Part 1
Standard Setup Mode
See Overview Part 2
Standard Setup Mode
See Overview Part 2
Use keys . and 0–9 to enter netmask.
Use C-key to erase.
Use keys . and 0–9 to enter netmask.
Use C-key to erase.
NETWORK:
IP SELECTION
SETUP:
NETWORK
NETWORK:
IP ADDRESS
IP ADDRESS:
10.1.12.79
NETMASK:
255.255.0.0
NETWORK:
NETMASK
Use keys . and 0–9 to enter router.
Use C-key to erase.
NETWORK:
DEFAULT ROUTER
DEFAULT ROUTER:
10.1.12.1
RARP
BOOTP
DHCP
IP SELECTION:
MANUAL
CR
LF
NET-COM,NET1:
NEW LINE
NEW LINE:
CR/LF
If an optional an EasyLAN 100i interface board is fitted, additional menus will be displayed.