User's Manual Part 2

Intermec EasyCoder F4 – Installation & Operation Ed. 2 53

Chapter 7

The method of entering the Setup Mode depends on whether the

printer is ﬁ tted with some kind of startup ﬁ le, a subject that was more

thoroughly discussed in the chapter 4 “Starting Up” earlier in this

manual, to which the alphabetic references below refer.

A. EasyCoder F4 with Intermec Shell

• Turn on the power.

• When the display shows the message “Enter=Shell; x sec.”,

press <Enter>.

• Press the < Setup> key (this facility can be used anywhere

within Intermec Shell).

• Set up the printer as described in this chapter.

• Return to Intermec Shell by pressing the <Setup> key.

B. EasyCoder F4 with a custom-made application program

• Normally, there will be no need to enter the Setup Mode

for custom-made application programs. Necessary provisions

for changing the setup, manually or automatically, should be

provided by the program.

Entering

Setup Mode

at Installation

Setup Mode