User's Manual Part 2

Intermec EasyCoder F4 – Installation & Operation Ed. 2 47
Chapter 6 Setting Up the Printer
Length, cont'd.
• The length setup also decides the amount of paper feed when
using “fi x length strip”.
• The length setup creates an “emergency stop”, which works when
the printer is set up for “Label (w gaps)”, “Ticket (w mark)”, or
“Ticket (w gaps)”. If the LSS has not detected a gap or mark
within 150% of the set length, the paper feed is automatically
stopped to avoid feeding out a whole roll of paper, because of
e.g. a blocked or faulty LSS.
By setting up the X-start, the Width and the Length, you will create
a “print window” inside which the printing can be performed.
Any object or fi eld protruding outside the print window in any
direction will cause an error condition (Error 1003 “Field out
of label”).
Setup Parameters, cont'd.
Media, cont'd.
PAPER FEED
DIRECTION
Dot #0
Dot-line
on printhead
X-start Width (1–832)
Origin
Length
Dot #831
10.3 mm (0.41")
PRINT
WINDOW
PRINT
WINDOW
max. 104.0 mm (4.095")
25 – 114.3 mm (1 – 4.5")