User's Manual

EasyLAN Wireless User’s Manual
A-6
General Commands (continued)
Command Description
set load en Enables the firmware reload after exit.
set load ho name Sets the node name of the boot host for NetWare firmware
load.
set load ip n.n.n.n Sets the IP address of the load host (TCP/IP firmware load).
set load so filename Sets the host filename of the firmware to load.
set pa password Sets the console password. The default password is access.
set port p1 ackh status Enables or disables pACKH on parallel port (for older
printers). Where status equals en for enabled or dis for
disabled.
set port p1 bid status Enables or disables bidirectional mode on the parallel port.
Where status equals en for enabled or dis for disabled.
set port p1 dvid status Enables or disables 1284 device ID queries on the parallel
port. Where status equals en for enabled or dis for disabled.
set port p1 ecp status Enables or disables 1284 ECP mode on the parallel port.
Where status equals en for enabled or dis for disabled.
set port p1 fstb status Enables or disables fast strobe mode on the parallel port.
Where status equals en for enabled or dis for disabled.
set port p1 nbuf status Enables or disables no buffering on parallel port. Where status
equals en for enabled or dis for disabled.
set pro password Sets the console protection password to prevent access to set
commands. (Use unprotect command to access set commands.)
set serve de Sets the node description string displayed with the show server
command.
set serve str n “…” Defines the EasyLAN Wireless BOT/EOT string.
set servi servicname protocol
status
Enables or disables specified protocol on the specified service.
Where status equals en for enabled or dis for disabled.
set servi servicename bot nn Sets the service BOT string to nn.
set servi servicename eot nn Sets the service EOT string to nn.
set servi servicename fi nn Sets the service filter to nn.
set servi servicename fms
matchnumber
Sets the service with the specified match string number.
set servi servicename frs
replacenumber
Sets the service with the specified replacement string number.
set servi ip servicename status Enables or disables IP jobs. Where servicename equals the
name of the service and status equals en for enabled or dis for
disabled.