User's Manual

EasyLAN Wireless User’s Manual
2-12
•
BOOTP sets the EasyLAN Wireless to use boot protocol to get an IP address.
•
RARP sets the EasyLAN Wireless to use reverse address resolution protocol to
get an IP address.
•
Static sets the EasyLAN Wireless to use the IP address set in the IP Address
field whenever it boots.
10. In the Gateway field, enter the address for the gateway or router that the EasyLAN
Wireless communicates through to other subnets using the form n.n.n.n where n is a
number from 0 to 255.
11. From the Data Rate dropdown list, select the throughput speed for the Ethernet
connection (1, 2, 5.5, or 11 Mbps).
12. Click OK to accept your changes and return to the Search screen.
Click Cancel to reject your changes and return to the Search screen.
Note:
If you are having trouble configuring an EasyLAN Wireless, click Cancel in the
Configuration screen. In the Search screen, click Clear to clear the list of print servers,
and start a new search. For help searching for the EasyLAN Wireless, see “To search
for the EasyLAN Wireless” earlier in this chapter.
For configuring the rest of the parameters in the Configuration screen, see “Using the
EasyLAN Wireless Admin Utility” in the next section.
Configuring the Radio Parameters
You can use the Web browser interface or the EasyLAN Wireless Admin utility to
configure the following radio parameters:
•
Channel
•
SSID
•
Mode
•
Speed
•
WEP