User's Manual

Installing the EasyLAN Wireless
1-9
1
To set radio and network communications
1. Make sure that your PC’s serial port is set to
•
115200 baud.
•
8 data bits.
•
No parity.
•
1 stop bit.
2. Connect the serial port on the EasyLAN Wireless to the serial port of your PC.
3. Open a HyperTerminal session, and press
Enter
to get the
Local>
prompt.
4. To set the radio SSID, type
set en ssid mynetwork
where
mynetwork
is the
SSID for the EasyLAN Wireless, and press
Enter
.
5. To set the radio boot method to ad-hoc or infrastructure, type
set en mo mode
where
mode
is
ad
for ad-hoc,
ps
for pseudo ad-hoc, or
in
for infrastructure, and
press
Enter
.
6. To enable WEP 64 bit, type
set en wep 64
, and press
Enter
.
Or to enable WEP 128 bit, type
set en wep 128
, and press
Enter
.
7. To set the radio WEP key, type
set en key# n
where
n
is a number from 1 to 4,
and press
Enter
.
8. To set the radio WEP encryption value, type
set en wep keyval value
where
value
is the hexadecimal value of the WEP encryption (10 hexadecimal values for
64-bit encryption or 26 hexadecimal values for 128-bit encryption), and press
Enter
.
9. To set the static IP address, type
set ip ad to n.n.n.n
where
n
is a number
from 0 to 255, and press
Enter
.
10. To set the subnet mask, type
set ip
su n.n.n.n
where
n
is a number from 0 to
255, and press
Enter
.
11. To set the router, type
set ip ro n.n.n.n
where
n
is a number from 0 to 255,
and press
Enter
.
12. To set the boot method to static instead of DHCP, type
set ip me static
, and
press
Enter
. If you are using a printer other than the 601XP, skip to Step 15.
13. (601XP only) To set the communications parameters to 57600 baud, type
set
port s1 sp 57600
, and press
Enter
.
14. (601XP only) To disable console mode, type
set port s1 co dis
, and press
Enter
.
15. To save the changes, type
save
, press
Enter
, type
ini
, and press
Enter
.
16. Type
exit
and press
Enter
.