User's Manual

Installing the EasyLAN Wireless

1-5

Understanding the EasyLAN Wireless

Before you install the EasyLAN Wireless, you should identify the following

components on the back of your printer:

picture of the back of the printer with the following components called out

Component Description

Antenna

connector

Attach the antenna to this connector.

Press down this switch for less than 5 seconds to print a test label on the

printer. The test label shows the current wireless and network settings of the

EasyLAN Wireless. Press the switch down for more than 5 seconds to reset the

EasyLAN Wireless to its factory default parameters. If you hold the test switch

down upon powering up, the wireless print option powers up in ad-hoc mode

on RF channel 11 with the SSID of

printer

Test switch

Note: If you press the test switch for more than 5 seconds, only the

EasyLAN Wireless is reset to the factory defaults. The rest of the

printer settings remain unchanged.

LEDs The green LED comes on when the wireless print option is powered on and

then goes out. The yellow LED comes on solid when a wireless network link is

established. The green LED blinks during wireless network activity.

Serial port

(DB9)

Use this port for connecting a serial device. You can also use this port to access

the command line console of the EasyLAN Wireless for configuration and

diagnostics.