User's Manual

EasyLAN Wireless User’s Manual
A-8
TCP/IP Commands (continued)
Command Description
set ip ra nn Sets the procedure used by the EasyLAN Wireless when
obtaining its IP address. By default the IP address is set along
with a default subnet mask and a router address that is the
same as the address of the load host. By setting nn to 1, the
subnet mask is not set. If nn is set to 2, the router address is not
set. If nn is set to 3, neither the subnet mask nor the router
address is set.
set ip ro n.n.n.n Sets the default router address.
set ip su n.n.n.n Sets the subnet mask.
set ip ti n Sets the inactivity timeout in minutes.
set servi servicename ip status Enables or disables TCP/IP jobs on specified EasyLAN
Wireless. Where servicename equals the name of the service
and status equals en for enabled or dis for disabled.
set servi servicename tcp nn Sets the TCP port number (>1023) on the specified service.
sh ip Shows LPD/TCP/TELNET parameters.
sh ip ac Shows IP addresses that are allowed to access the EasyLAN
Wireless.
NetWare Commands
Use these commands to configure and manage NetWare parameters.
Command Description
cl netw se server Removes the specified NetWare file server from the EasyLAN
Wireless access list.
set netw ad n Sets the advertising frequency of the EasyLAN Wireless.
set netw status Enables or disables the NetWare protocol on the EasyLAN
Wireless. Where status equals en for enabled or dis for
disabled.
set netw fr type Sets the NetWare frame type. Where type equals 802.2, 802.3,
eth for Ethernet II, al for all, au for auto, or sna for SNAP.
set netw ne n Sets the NetWare internal network number.
set netw np pserver n on
service
Set NPrinter mode on the specified service.
set netw pa password Sets the EasyLAN Wireless login password for the file server.
set netw po n Sets the queue polling time in seconds.