User's Manual

Console Commands
A-7
A
General Commands (continued)
Command Description
set servi
servicename
na
newname
Changes the service name.
set servi
servicename
rec
status
Enables or disable receive only mode on the specified service.
Where
servicename
equals the name of the service and
status
equals en for enabled or dis for disabled.
sh fa Shows the fatal error log.
sh fr Shows the memory available.
sh loa Shows the firmware update parameters.
sh po Shows the port parameters.
sh po p1 sta Shows the current port status.
sh serve co Shows the EasyLAN Wireless statistics.
sh servi Shows the service parameters.
sh te Prints the test label.
sh ve Shows the EasyLAN Wireless firmware version.
unpro Allows the system manager to temporarily access set
commands when the remote console is in protected mode. The
set default command can be used to permanently disable the
protected mode.
ze Zeroes statistical counts.
TCP/IP Commands
Use these commands to configure and manage TCP/IP parameters.
Command Description
set ip ac
status n.n.n.n
Enables or disables specified IP address from accessing the
EasyLAN Wireless. Where
status
equals en for enabled, dis
for disabled, or all for enabling all IP addresses and
n.n.n.n
equals the specific IP address.
set ip ad
n.n.n.n
Sets the IP address of the EasyLAN Wireless.
set ip bo
n
Sets the number of BOOTP/RARP tries.
set ip
status
Enables or disables IP processing. Where status equals en for
enabled or dis for disabled.
set ip meth stat Sets IP to static address so that the EasyLAN Wireless will not
look for a DHCP address.