User's Manual
Table Of Contents
- Before You Begin
- Chapter 1 - Using the CV30 Fixed Mount Computer
- Chapter 2 - Understanding Windows CE
- Chapter 3 - Configuring the CV30
- Configuring the CV30 Operating Parameters
- Setting Up Ethernet Communications
- Setting Up Bluetooth Communications
- Setting Up 802.11 Radio Communications
- Configuring Security on the CV30
- Understanding the Wireless Network
- Using WPA Security
- Using Static WEP Security
- Using 802.1x Security
- Using LEAP Security
- Choosing Between Funk and Microsoft Security
- Configuring Funk Security Using Intermec Settings
- Configuring Funk Security Using the Profile Wizard
- Configuring WEP Security With Profile Wizard
- Configuring WPA-PSK Security With Profile Wizard
- Configuring WPA2-PSK Security With Profile Wizard
- Configuring PEAP Security With Profile Wizard
- Configuring TLS Security With Profile Wizard
- Configuring TTLS Security With Profile Wizard
- Configuring LEAP Security With Profile Wizard
- Configuring EAP-FAST with Profile Wizard
- Configuring Microsoft Security
- Loading a Certificate
- Disabling Security
- Chapter 4 - Developing and InstallingApplications
- Chapter 5 - Troubleshooting andMaintaining the CV30
- Appendix - Specifications
- Index
Chapter 3 — Configuring the CV30
CV30 Fixed Mount Computer With Windows CE User’s Manual 51
Configuring WEP Security With Profile Wizard
1 In the Profile Wizard, select the Security page.
2 For 8021x Security, choose None.
3 For Association, choose Open or Shared to match the
settings on your access point.
4 For Encryption, choose WEP.
5 From the Data TX Key list, select the key you want to use for
transmitting data.
6 Define a value for the keys you want to use. You can define up
to four keys (Key 1 through Key 4).
Enter an ASCII key or a hex key that is either 5 bytes or 13
bytes long depending on the capability of the radio. Set a 5-
byte value for 64-bit WEP or a 13-byte value for 128-bit
WEP. Hex keys must be preceded by 0x and contain 5 or 13
hex pairs.
7 Tap OK.
Configuring WPA-PSK Security With Profile Wizard
1 In the Profile Wizard, select the Security page.
2 For 8021x Security, choose None.
3 For Association, choose WPA.