User's Manual

Chapter 3 — Configuring the CV30
CV30 Fixed Mount Computer With Windows CE User’s Manual 39
Configuring the Network Parameters for a UDP Plus Network
In a UDP Plus network, the CV30 communicates with a host
computer through the Intermec Application Server. The
Intermec Application Server translates UDP Plus packets on the
wireless network into TCP/IP packets on the wired network and
vice versa. The access point acts as a bridge to allow
communications between the wired network and the wireless
network.
To use wireless communications in a UDP Plus network
1 Go to Start > Settings > Control Panel > Intermec Settings.
2 Configure these network parameters on the CV30:
• Network name (SSID)
• Controller IP address
• IP settings (if not using DHCP)
• Network port
3 Configure security. For help, see “Configuring Security on the
CV30” in the next section.
4 Make sure the CV30 is talking to the network and that the
network can see the CV30.
Checking the Status of Your Wireless Connection
After you configure your wireless settings, you can use iConnect
to check the status of your connection.
To check the status of your wireless connection
1 Tap the iConnect icon ( ) in the lower right corner of the
Today screen.
2 From the menu, select Status > Wireless. The Wireless Status
screen appears and checks the connection.
You can also use iConnect to configure the network settings if
you need to change anything by tapping To o l s > Wireless
Settings from the iConnect menu.