User's Manual

Chapter 2 — Configuring the CK30
CK30 Handheld Computer User’s Manual 37
The DCS 30X or G4000 translate UDP Plus packets on the RF
network into TCP/IP packets on the wired network and vice
versa. The access point acts as a bridge to allow communications
between the wired network and the RF network.
To use RF communications in a UDP Plus network
1 Configure these network parameters on each CK30 in the
network:
• Network Name (SSID)
• Controller IP Address
• IP Settings (if not using DHCP
• Network Port
• Default Router (DCS 30X or G4000 on different
subnetwork)
• Subnet Mask (DCS 30X or G4000 on different
subnetwork)
2 Configure the security.
The easiest way to configure the network parameters on the
CK30 is to use the Configuration Utility. For help, see
“Configuring the CK30 With the Configuration Utility” on
page 28.