User's Manual

Chapter 2 — Configuring the CK30
34 CK30 Handheld Computer User’s Manual
• Connect the AD1 or AD2 Communications Dock to the
serial port of the other device using a DB9-pin to DB9-pin
serial adapter cable.
3 Turn on the CK30.
Using RF Communications on the CK30
Make sure all components with antennas are at least 30 cm
(1 ft) apart when power is applied. Failure to comply could
result in equipment damage.
Attention: Assurez-vous que la distance entre tous les
éléments avec antennes soit d’au moins 30 centimètres (un
pied) avant de faire la connexion avec l’alimentation
électrique, faute de quoi vous risquez d’endommager votre
installation.
The CK30 has an internal antenna to transfer data using RF
communications. This section of the manual assumes that you
have already set up your RF communications network including
your access points. If you are using a UDP Plus network, you
also need to have your DCS 30X or G4000 communicating
with a host computer.
If you are using 802.1x security, this section also assumes that
your authentication server and access points are properly
configured and that they have been set to the current date and
time.
Your CK30 supports one of the following types of network
protocol:
• TCP/IP
• UDP Plus
The next sections explain the parameters you need to configure
for the CK30 to work in your RF network.