User's Manual

Chapter 2 — Configuring the CK30

32 CK30 Handheld Computer User’s Manual

You can only change some of the configuration parameters by

scanning bar codes. To configure all of configuration

parameters, use the Configuration Utility, send commands

through the network to your Ck30, or use the Intermec

Configuration Utility.

For example, you can use the Beep Volume configuration

command to adjust the beep volume of the CK30. Scan this bar

code label to set the volume to the lowest level:

Set Beep Volume to Low

*$+BV1*

When you scan bar code configuration commands, the CK30

emits a series of beeps unless the volume is turned off. There are

two beep sequences:

• One high beep means you scanned a valid configuration

command.

• Three low beeps means you scanned an invalid configuration

command.

How the CK30 Fits Into Your Network

The CK30 is a versatile handheld computer that you can easily

add to your wired or wireless data collection network. You can

connect your CK30 to your network using:

• Serial Communications

• RF Communications

• Ethernet Communications

• Bluetooth Wireless Printing