User's Manual

Chapter 2 — Configuring the CK30
CK30 Handheld Computer User’s Manual 31
2 Press Enter to restore factory defaults.
A progress bar appears on the screen to show you the status of
restoring the factory defaults.
Exiting the Configuration Utility
When you exit the Configuration Utility, you leave the
password-protected area of the CK30. The password-protected
icon (
) disappears from the status bar.
To exit the System Main Menu
1 From the System Main Menu, press Esc or select Exit.
2 When asked if you want to exit the System Main Menu,
press Enter.
Configuring the CK30 With Commands Through the Network
You can change the configuration parameters of the CK30 by
sending commands through a host computer or through the
network. If you are using a network, you can configure one or
more CK30 at a time. For help, see Chapter 2 of the CK30
Handheld Computer Configuration Manual.
Configuring the CK30 With the Intermec Configuration Utility (ICU)
I don’t have any information to put here yet….
Configuring the CK30 by Scanning Bar Codes
You can change the configuration parameters of the CK30 by
scanning Code 39 or Code 93 bar codes labels containing
configuration commands. This method is a fast and easy way to
change just a few configuration parameters on a single CK30.
You can scan the bar code labels in the CK30 Handheld
Computer Configuration Manual or you can create your own bar
code labels. Chapter 2 in the Configuration Manual describes
how to create your own bar code labels.