User's Manual

Chapter 1 — Using the CK30 Handheld Computer
CK30 Handheld Computer User’s Manual 21
When the CK30 successfully reads a bar code label, you will
hear a high beep and the green Good Read LED turns on
briefly.
4 Release the Scan button.
Scanning Bar Codes With the 2D Area Imager
The CK30C may have a 2D area imager instead of the
conventional laser scanner. Omni-directional (360°) scanning
means that you can position the CK30 in any direction to scan a
bar code label.
To scan a bar code label with the 2D area imager
1 Press Power to turn on the CK30.
2 Point the scanner window at the bar code label and hold the
computer a few inches from the label.
3 Press the Scan button on the keypad and center the red
aiming beam over the bar code label.
Note: The aiming beam is smaller when the imager is closer
to the bar code and larger when it is further away.
Insert illustration