User's Manual

Chapter 1 — Using the CK30 Handheld Computer
CK30 Handheld Computer User’s Manual 19
You can change the beep volume and duration to accommodate
your needs and environment. When you change the beep
volume, you also change the keyclick volume if you have the
Keypad Clicker command enabled. The keyclick is the sound
you hear when you press a key.
You can set the beep volume to off, low, medium, and high
(default). Use one of these three ways to change the beep
volume:
Method Procedure
Use the keypad.
Press the Green key, Backlight key to increase the
volume. There are four beep volumes on the CK30
including off. When you reach the loudest setting,
the next setting is off. The volume will then start
with the lowest setting and go up.
Use the Intermec
Configuration menu.
From the Intermec CK30 menu, choose
Configuration Utility > CK30 Settings > Beeper
and LED.
Use the Beep
Volume command.
For help, see “Beep Volume” in the CK30 Handheld
Computer Configuration Manual.
Scanning Bar Codes
Do not look directly into the window area or at a reflection
of the laser beam while the laser is scanning. Long-term
exposure to the laser bean can damage your vision.
Avertissement: Ne regardez pas directement la réflexion d’un
rayon laser ou dans la fenêtre du laser lorsque celui-ci est en
opération. Si vous regardez trop longtemps un rayon laser,
cela peut endommager votre vue.
Use the scanner to scan and enter bar code data. The type of
scanner you are using and the type of bar code you are decoding
determines the way you scan the bar code. The CK30 supports
the scanning of 1D linear bar codes and 2D images depending
on your model of CK30. Plus, if you have are using an
integrated handle or a tethered scanner, the way you scan bar
codes will be different.