User's Manual

Operation—Chapter 2
216820 Series 80-Column Printer User’s Manual
Adjusting the Pinfeed Holders
Note: There are two pinfeed holders, one next to the green thumb wheel
and one opposite the same wheel. Always loosen the pinfeed holder oppo-
site the green thumb wheel.
Note: Adjusting the pinfeed holder next to the green thumb wheel may
cause information to print in the wrong place. If this pinfeed holder is
moved, correct its location by releasing the pinfeed holder tab, moving the
pinfeed holder as close to the green thumb wheel as possible, then locking
the pinfeed holder tab, bef ore adjusting the opposite pinfeed holder.
If the paper does not fit on the two pinfeed holders properly, follow these
steps to adjust the area between the two pinfeed holders to fit the width of
the paper. See the following illustration.
1 With the pinfeed holders open, release the locking tab on the pinfeed
holder opposite the green thumb wheel.
2 Adjust the pinfeed holder position so that the pins align with the paper.
3 Close the pinfeed holder.
4 Ensure that the paper is smooth (no folds, bulges, bows, etc.) between
the pinfeed holders. If so, push the locking tab down on the pinfeed
holder that you adjusted.
Locked
pinfeed holder
locking tab
Pinfeed
holder
Release d
pinfeed holder
locking tab
Thumb wheel
(green)