User's Manual

Operation—Chapter 2
156820 Series 80-Column Printer User’s Manual
Installing Internal Battery
The optional internal battery (sold separately — see “Inside Sales” in Chapter
1 for ordering information and part number) is primarily for por table print-
ers; not wall mount printers. Thebatterycangoinsomefixedmountprint-
ers via a cable and a factory-installed adapter.
The printer battery recharges automatically when the printer is connected
to an external power source via power cable. For most installations, the
external power source is passed through the printer to the mobile comput-
er. The printer battery does not providechargetothecomputer.
Note: Remove the printer battery when storing a printer for over 30 days.
After storage, reinstall the battery and connect the printer to an external
power source for at least two hours, to recharge the battery.
1 Unlatch and open the printer mechanism.
2 Lower the battery into the rear of the printer case, as shown.
3 Attach the battery cable to the battery.
4 Push the battery down and back under the back edge of the case. The
battery should snap into place.
5 Close and latch the mechanism.
Battery
Battery
cable
Printer mechanism
(raised)
Latches or
rubber bumpers