User's Manual Part 4

Appendix B — Bluetooth Configuration Commands and Specifications
6822 Series 80-Column Printer User’s Manual 137
Set Local Bluetooth Device Name
Set Class of Device/Service Field
Set Service Name
Connectable On/Off
Note: These commands are only available over the serial link,
not over the air and are not available when the device is in the
“Bluetooth Link Active State.”
Command
F0<Device Friendly Name><CR>
Definition
“Device Name” — String up to 254 bytes long
Default
“6822-DDEEFF” where DDEEFF is from the
(AABBCCDDEEFF) Bluetooth device address
Example
“F01Len’s 100%25 serial module<CR>“
This sets the name to “Len’s 100% serial module.”
Command
S1< Class of Device/Service field >
Description
The Class of Device/Service (CoD) field is a 24-bit
field defined in the Bluetooth Assigned Numbers
document. This field is sent in a HEX ASCII
format, most significant byte first.
Example
“S1001F00<CR>” is a common Class of Device
value for a basic serial device.
Command
S2<Service Name>
Description
Sets the service friendly name to send to the remote
Bluetooth device in response to a service discovery
request. The length of the service name is limited to
32 bytes.
Definition
Profile Name — text name entered into the SDP
record for the serial port profile
Default
“Wireless Printer”
Example
“S3Acme Printer<CR>”
Command
C0 <ON|OFF><CR>
Description
Sets the device into “connectable” mode