User's Manual Part 4

Appendix C — Cross-Reference Tables
176 6822 Series 80-Column Printer User’s Manual
The settings in the previous table are installed in the printer at the factory.
To restore the printer to these defaults, see Reset Button on page 4 for
instructions.
The default settings listed below can be restored to the printer, as described
in Chapter 4 “Using the 6820 Printer Configuration Utility”.
Keyboard, printer Enabled
Language USA
Line Spacing 1/6 inch
Margin, left 0
Margin, right 80
MSB control Disabled
NLQ Disabled
Page length 11 inch (66 lines with Pica
pitch)
Paper end sensor Enabled
Pitch Pica (10 characters per inch)
Power off sleep timer 10 seconds
Printer Code Area Expansion Disabled
Printing direction Top-down, bidirectional
Redefinition of graphic modes Disabled
Skip over perforation Disabled
Subscript/Superscript Disabled
Tabs, horizontal Set to default tabs (every 8
column)
Tabs, ve r ti c al 1 line feed each tab, channel = 0
Top of form Set to current line
Underline Disabled
Unidirectional printing Disabled (bidirectional)
User defined character set Removed
Factory-Installed Printer Defaults (continued)
Function Default Value