User's Manual
Table Of Contents
- Before You Begin
- Chapter 1 - Using the CV30 Fixed Mount Computer
- Chapter 2 - Understanding Windows CE
- Chapter 3 - Configuring the CV30
- Configuring the CV30 Operating Parameters
- Setting Up Ethernet Communications
- Setting Up Bluetooth Communications
- Setting Up 802.11 Radio Communications
- Configuring Security on the CV30
- Understanding the Wireless Network
- Using WPA Security
- Using Static WEP Security
- Using 802.1x Security
- Using LEAP Security
- Choosing Between Funk and Microsoft Security
- Configuring Funk Security Using Intermec Settings
- Configuring Funk Security Using the Profile Wizard
- Configuring WEP Security With Profile Wizard
- Configuring WPA-PSK Security With Profile Wizard
- Configuring WPA2-PSK Security With Profile Wizard
- Configuring PEAP Security With Profile Wizard
- Configuring TLS Security With Profile Wizard
- Configuring TTLS Security With Profile Wizard
- Configuring LEAP Security With Profile Wizard
- Configuring EAP-FAST with Profile Wizard
- Configuring Microsoft Security
- Loading a Certificate
- Disabling Security
- Chapter 4 - Developing and InstallingApplications
- Chapter 5 - Troubleshooting andMaintaining the CV30
- Appendix - Specifications
- Index
Chapter 1 — Using the CV30 Fixed Mount Computer
CV30 Fixed Mount Computer With Windows CE User’s Manual 9
Attaching the CV30 to Power Using an AC Power Supply
Understanding the Backup Power System
The CV30 contains a backup battery that has enough capacity to
support the suspend state for at least 72 hours. When power is
restored to the CV30, it resumes the state it was in when the
power was removed.
An internal charger automatically charges the backup battery
within 4 hours when external power is supplied. If the backup
battery fails, an amber light on the top of the display turns on.
You must replace your backup battery immediately if you see an
amber light. The backup battery must be replaced by a trained
Intermec service technician. Please contact your local Intermec
service representative for more information.
To check the status of your backup battery
•Tap Start > Settings > Control Panel > Power.
Resetting the CV30
You rarely need to reset the CV30. If the CV30 does not resume
after pressing the Power button, or if the computer or an
application is locked up, you may need to reset it. The CV30 uses
the configuration currently saved in flash memory during the
boot processes. There are two ways to reset the CV30:
•Using the Power button
AC outlet
AC power
supply
Power
cord