User's Manual

Chapter 1 — Using the CV30 Fixed Mount Computer
8 CV30 Fixed Mount Computer With Windows CE User’s Manual
2 From the Control Panel, Double-tap Stylus. The Stylus
Properties dialog box appears.
3 Tap the Calibration tab > Recalibrate and follow the
instructions to align the screen.
If the touch screen is so out of alignment that you cannot open
the Start menu, you may need to perform a clean boot. After the
computer clean boots, it prompts you to align the screen. For
more information on performing a clean boot, see
“Troubleshooting the Boot Process (Clean Booting)” on
page 89.
Attaching the CV30 to Power
For the CV30 to operate, you must provide power to the CV30
through a DC/DC power supply or an AC/DC power supply.
The CV30 also has a backup battery to sustain all memory and
applications when power is not supplied. You must have a power
supply connected to the CV30 for it to operate.
Use the AC power supply and power cord when you are using the
CV30 with a desk mounting kit or a wall mounting kit. The AC
power supply does not provide power for the internal touch
screen heater. You must order the AC power supply and country-
specific power cord separately.
There are two DC/DC power options for the CV30. You must
order one of these DC/DC power options separately:
• DC/DC heated/non-heated (6-60 VDC) power supply
(P/N 203-779-001)
• DC/DC heated/non-heated (15-96 VDC) power supply
(P/N 203-832-001)
For more information on installing the DC power options, see
the CV30 Vehicle Power Supply Installation Guide (P/N 932-007-
001).