User's Manual
Table Of Contents
- Before You Begin
- Using the CK32 I-Safe Handheld Computer
- Understanding Windows Mobile
- Configuring the CK32 I-Safe
- Configuring the Operating Parameters
- Setting Up Ethernet Communications
- Setting Up Bluetooth Communications
- Setting Up 802.11 Radio Communications
- Configuring Security on the CK32 I-Safe
- Developing and Installing Applications
- Troubleshooting and Maintenance
- Specifications
- Physical and Environmental Specifications
- Accessories
- AN1 Communications Adapter (P/N 871-223-xxx)
- AC11 Quad Battery Charger (P/N 852-914-xxx)
- Handle (P/N 714-625-xxx)
- Hand Strap (P/N 825-183-xxx)
- Carrying Strap Kit (P/N 825-186-xxx)
- AB6 Battery Pack (P/N 318-021-xxx)
- Tethered Stylus (P/N 203-828-xxx)
- Battery Eliminator (P/N 714-619-xxx)
- Power Supply (P/N 851-061-xxx)
- Screen Protector (P/N 346-065-004)
- Index
Chapter 1 — Using the CK32 I-Safe Handheld Computer
CK32 I-Safe Handheld Computer User’s Manual 21
6 Release the Scan button.
To scan a PDF417 or Micro PDF417 bar code and verify scanner operation
1 Press the Power button to turn on the CK32 I-Safe.
2 Point the scanner window PDF417 or Micro PDF417 bar
code label and hold the computer at a slight angle 15 to
25 cm (6 to 10 in) from the label.
3 Press the Scan button on the keypad or pull the trigger on a
handle, and direct the red beam so that it falls across at the
top row of the bar code label.
Scanning a PDF417 or Micro PDF417 Bar Code Label
Use this test bar code:
PDF417 Test Bar Code
*123456789abcdefg*
4 Move the beam down all rows of the bar code label. The
CK32 clicks as it reads each row.
5 The CK32 I-Safe emits a high beep and the green Good Read
light turns on briefly when the CK32 I-Safe successfully reads
the entire bar code label.