User's Manual
Table Of Contents
- Before You Begin
- Using the CK32 I-Safe Handheld Computer
- Understanding Windows Mobile
- Configuring the CK32 I-Safe
- Configuring the Operating Parameters
- Setting Up Ethernet Communications
- Setting Up Bluetooth Communications
- Setting Up 802.11 Radio Communications
- Configuring Security on the CK32 I-Safe
- Developing and Installing Applications
- Troubleshooting and Maintenance
- Specifications
- Physical and Environmental Specifications
- Accessories
- AN1 Communications Adapter (P/N 871-223-xxx)
- AC11 Quad Battery Charger (P/N 852-914-xxx)
- Handle (P/N 714-625-xxx)
- Hand Strap (P/N 825-183-xxx)
- Carrying Strap Kit (P/N 825-186-xxx)
- AB6 Battery Pack (P/N 318-021-xxx)
- Tethered Stylus (P/N 203-828-xxx)
- Battery Eliminator (P/N 714-619-xxx)
- Power Supply (P/N 851-061-xxx)
- Screen Protector (P/N 346-065-004)
- Index
Chapter 1 — Using the CK32 I-Safe Handheld Computer
CK32 I-Safe Handheld Computer User’s Manual 5
Charging and Installing the Battery
Make sure you fully charge the AB6 battery before using your
CK32 I-Safe.
To charge the battery
• Insert the battery into the AC11 4-slot battery charger.
Charging time is approximately 7 hours.
To install the battery
• Insert the tabs on the bottom of the charged battery into the
CK32 I-Safe and snap the battery into place.
Inserting the AB6 Battery
You must suspend your CK32 I-Safe before removing the
battery, or data loss may occur.
Battery latch
Beeper
AB6 battery
Speaker
(internal)
Explosion Hazard – Use Intermec battery pack Model AB6
only. It is rated as Intrinsically Safe but it MUST NOT BE
CHANGED while in a Class II or Class III environment. The
battery can be changed in a Class 1 (gas) environment.