User's Manual
Table Of Contents
- Before You Begin
- Using the CK32 I-Safe Handheld Computer
- Understanding Windows Mobile
- Configuring the CK32 I-Safe
- Configuring the Operating Parameters
- Setting Up Ethernet Communications
- Setting Up Bluetooth Communications
- Setting Up 802.11 Radio Communications
- Configuring Security on the CK32 I-Safe
- Developing and Installing Applications
- Troubleshooting and Maintenance
- Specifications
- Physical and Environmental Specifications
- Accessories
- AN1 Communications Adapter (P/N 871-223-xxx)
- AC11 Quad Battery Charger (P/N 852-914-xxx)
- Handle (P/N 714-625-xxx)
- Hand Strap (P/N 825-183-xxx)
- Carrying Strap Kit (P/N 825-186-xxx)
- AB6 Battery Pack (P/N 318-021-xxx)
- Tethered Stylus (P/N 203-828-xxx)
- Battery Eliminator (P/N 714-619-xxx)
- Power Supply (P/N 851-061-xxx)
- Screen Protector (P/N 346-065-004)
- Index
Chapter 5— Troubleshooting and Maintenance
CK32 I-Safe Handheld Computer User’s Manual 105
Problems While Operating the CK32 I-Safe
Problem Solutions
You press the Power button to turn
on the CK32 I-Safe and nothing
happens.
Make sure the backlight is on by pressing E.
Make sure you have a charged battery installed correctly.
For help, see “Charging and Installing the Battery” on
page 5.
The battery may be discharged. Replace the battery with a
spare charged battery, or charge the battery and try again.
The Battery light is blinking. The battery is running low. Replace the battery with a
spare charged battery, or charge the battery.
You use your stylus to tap the screen
and nothing happens.
Recalibrate your touch screen. For help, see “Using the
Touch Screen” on page 14.
The blue Ready-to-Work indicator
is off.
Try these possible solutions:
The Ready-to-Work application (such as TE 2000) has
not loaded successfully. For help, see the documentation
or online help for the application.
The CK32 I-Safe is not running a Ready-to-Work
application.
The blue Ready-to-Work indicator
is blinking.
The Ready-to-Work application (such as TE 2000) may
be running, but is not connected to a host. Verify that the
application is properly configured to communicate with
the host.
The blue Ready-to-Work indicator
is on.
A connection has been established, and all network
connections are active. There is nothing to troubleshoot.