User's Manual

Chapter 1 — Using the CN30 Mobile Computer
CN30 Mobile Computer User’s Manual 17
Using the SD Card
You can use a Secure Digital (SD) card to increase file storage and install
software. The CN30 currently supports SanDisk SD cards only. The SD
card slot is located on the side of the CN30.
To insert an SD card
1 Press (I) to turn off the CN30.
2 Remove the two screws on the SD card slot door and remove the door.
3 Gently insert the SD card into the CN30 with the printed side facing
the keypad and screen side of the CN30.
4 Push the card into the slot until it latches in place and the steel card
retainer covers the end of the SD card.
5 Replace the door, making sure to insert the door catch into the slot
above the steel card retainer.
6 Replace the two screws.
7 Press (I) to turn on the CN30.
To remove the SD card
1 Press I to turn off the CN30.
2 Remove the two screws on the SD card slot door and remove the door.
3 Push in on the SD card until you hear it unlatch. The card should eject
far enough that you can easily remove it from the CN30. If the card does
not eject easily, you can use the door catch to remove it by turning the
door upside down and using the catch to pull out the SD card.
4 Remove the SD card from the CN30.